INCLINOMETER CM 09606
Product Ref: CM 09606
Price: €0.00
Sorry, this product is out of stock.
Structure and function
The inclinometer CM-09606 consists of the handheld unit with graphics module and sensor for measuring two levels. The measuring range is +/- 15°.
To measure the lower transverse link of the front axle, the provided magnetic adaption plate 09606-50 is set in the designated recess to provide support for the sensor.
Place the sensor with the points onto the adaption plate. The gauge results are shown on the display and saved by pressing the "Save" key. For gauging both the left and right side of the vehicle, ensure the spiral cord points toward the middle of the vehicle.
No adapter is needed for measuring the rear axle shaft. The sensor points can be held directly onto the drive shaft (exception M Class W163; see accessories). Once again the spiral cord should point toward the center of the vehicle. After saving all four measurements, the data can be transmitted to the wheel alignment computer either via interface (serial or USB) or by using the accessory unit "Data transfer and charging station 09630-10". The precise settings will be assigned automatically.
Characteristics
- high gauge accuracy
- easiest handling
- power supplied by customary rechargeable batteries (4 x Mignon AA 1.2V/2100 mAh)
- battery charger
Technical data
- CE certificate, Protection IP65
- Power supply: 4.8V – 6V, 0.8W
- Angle measuring range: +/- 15°, accuracy +/- 0.1°
- Equipment: USB-Interface and serial R232 for data Transfer, battery charger (12V/250mA)
- Measurements (in mm): L x W x H: 450 x 380 x 120 (with case) app. 130 x 280 x 70 (without case)
- Packing measurements (in mm): L x W x H: 455 x 400 x 120
